This research is a continuation of synthetic jet characteristics investigation over convective cooling of impinging jet model. The synthetic jet cooling uses an air flowing in a vertical direction into the heated wall. This model uses an oscilating membrane to push and pull the air from and to the cavity. The purpose of this model of synthetic jet is to create vortices pair to come out from nozzle which will accelerate the heat transfer process occurring at the wall. This heat transfer enhancement principle has became the basis to simulate an alternative cooling system in order to substitute the conventional fan cooling in electronic devices due to its advantage for having a small form factor and low noise. The investigation is conducted in the computational work. In this research, the synthetic jet prototype model was simulated to examine the distribution of heat flow on the walls using a mathematical turbulent model k-ω SST. Meshing order was elements Tet/Hybrid and type Tgrid and the number of grid was more than 233.886 in order to ensure detail discretization and more accurate calculation results. This simulation used a triangular waveform as it excitation source. The frequencies of excitation were 80 Hz, 120 Hz, 160 Hz and the amplitude was 1 m/s. Using this variation, the main goal is to increase the heat transfer coefficient generated by the synthetic jet blow.